Questions & Answers for: steering adjustment outboard

...steering column shroud by place the bottom screw in the No.1 position and pulling the shroud up and away from the column. On automatics, remove the shift indicator cable. Remove the instrument panel ...

...outboard is square to the boat? When starting out the boat really leans to the port side and stays that way until i reach around 40mph ? Does the steering pull to one side while coming up to speed. ...

...outboard play as far as handling and hard steering, and how do you adjust it? If you are talking about the small tab under the cav. plate.Its job is to counteract the effect that the prop has on ...

outboard 4.3l stiff steering 1989 galaxie boat. inboard/outboard 4.3l mercruiser with cobra outdrive. my steering wheel is really stiff and hard to turn. is there a quick fix? any fix? if i cant do it

the tiller? Normally with such a set up you increase the steering friction adjustment till the motor is to all intents and purposes locked solid. I don't recommend having it moving if you can stop it

...steering column, remove the two outboard screws that secure the upper column shroud (1) to the lower shroud (3). 4. Using hand pressure, press inward on both sides of the upper shroud above the ...

...outboard not pumping water, overheating You should change your impeller. It is located at the top of the gearbox, around the vertical engine shaft. First, disconnect the gear control. Underneath the ...

how do you adjust steering handle on older 6hp chrysler outboard not sure of age I think I would spray it down good with wd40 and wait a few days .

steering on Honda outboard Check your trim tab on bottom of motor and adjust it to run straight. Be sure your steering cable is not bound up. Grease the steering cylinder on the motor if equipped with

...outboard and it seems like I have to turn the steering wheel several rotations before the engine/pontoon boat starts to turn, Kevin Callele...Regina, Saskatchewan check steering gear / cables If your ...