Questions & Answers for: status light blinking lcd

Question about WD62527 62 in. LCD HDTV

1 Answer

...status light blink slowly. The lamp flashes green and the status flashes yellow. After about one minutes, only the status light flashes. According the the manual, a yellow status light blinking ...

Ad

...status light (.5 sec on, 2.5 sec off) indicating a lamp housing or cover error. yes it was the problem of broken tab - which is holding micro switch of lamp was broken when removing the cover and it ...

Ad

...status light just continue to blink with no illumination I had the same issue, what I figured out was that I never removed the lamp door correctly, causing a small plastic piece to break off. To see ...

...status light blinks Info: Display is blank and the status light blinks faint blue Info: Power supply made by Delta Electronics P/N: DAC-12M033 The problem can be occurred due to low voltage the ...

Question about VT800 LCD Projector

1 Answer

...green then it goes to a flashing orange light there should be a status for the lamp light; check to see if this one turns red. If it does count the consecutive blinks if it is 6 then replace the ...

Question about WD-62528 62" LCD HDTV

1 Answer

Status Light Problem My television won't turn on. When you activate the Power button, the status light and lamp lights will come on. The lamp light will turn off but, the "status" light is still on ...

Question about VT491 LCD Projector

1 Answer

...status light flashes... then it turns itself off, except the power button is still showing power and the status light is blinking red Your bulb is not lighting. Either the bulb has failed or it has a ...

Question about Aquos LC-37HV4U 37 in. LCD HDTV

0 Answer

light blinking,which means the unstable status.Most time,it should be the situation that LED light inside went broken,you might as well test LED's function or ask for repairing.Wish tips here

Question about MultiSync MT1065 Multimedia Projector

1 Answer

status light blinks seven times Won't power on. Just changed the bulb (MT60LP). No sounds of powering on either. Red status light just blinks seven times, pauses, then blinks seven times, etc. ...

...status light...does nothing else...reset does no good, also tried to reload software with no difference. Replaced power and inverter boards button stop the same. No obvious bad components on boards. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Cindy Wells

Level 3 Expert

6688 Answers

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

Are you a Televison & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...