Questions & Answers for: start washing machine cycle interrupted

...end cycle button was unlocked/ended. The drain/spin cycle is what I have tried to start. unplug it wait a few mins---- that should solve it sometimes these machines go in to a a "soft lock" ...

washing cycle on coin operated Mah21pddww We don't know a way to interrupt the washing cycle on coin operated washers once they have started. Apparently, once in a while, something gets wedged between

washing machine starts a cycle properly and then it stops somewhere during the process (not the same place each time) and the display shows there is a power interruption and it stops at that point. If

...start up again but my clothes are soaked at the end of the cycle. i have cleaned the lint trap. any help is appreciated. Repair Manual Link Ours does the same thing. It appears if we interrupt the ...

washing machine cycle was interrupted and was not restarted properly. If you try to modify the cycle or start a new one before the first cycle is complete, the PAU error will appear on the display. If

...and won't start any cycle. Try to turn circuit breaker off, or unplug unit, for about 5-6 minutes. This is a hard reset and should reset the internal controls to restart the unit

...to try to reset. 10 minutes later the cycle lights come back on and it starts to beep again. The wash cycle was never interrupted and went thru completion until finished. sounds like a timing

...machine doesn't turn on. When I push start button it beeps but doesn't light up or turn on. You interrupted the cycle and now the memory has been compromised. You may have to call the manufacturer to ...

...machine back on, but two cycle lights come on simultaneously ("intense" and "normal"). Cannot re-set the system in order to start a new load It didn't like the power interruption. (just like a ...

...Machine wont start a cycle. It can do a clean cycle which I find a little odd. Checked hoses and pump area with no obvious issues. That sounds like you are on Pause or Delayed Start. Try Pressing and ...