StarBoard Fx-77 Pen does not write on the boards surface The Fx-77 board is detected by the computer and StarBoard software shows that the board is connected, When we try to write on the boards ...
Question about 297 Secondary Station Control For 296 5 /Spotlight
...starboard. Now you will take the positive lead from bank 1 and connect it to B1 on the port switch and then jumper it to B1 on the starboard switch. You will do the same for bank 2 and the starboard ...
...throttle body being blocked by carbon. The idle control valve is under the air filter duct, on the starboard (right side when facing forward) side of the throttle body (not the de-icer under the
starboard does not connect to the computer through the USB If you have the ability and space then recover any files that you can use the RUN option from the start menu now type in "cmd" then ENTER Now
Question about StarBoard FX-77
I keep getting the error message 'LSAdrv - Touch Sensor Error USb touch sensor error USB (7) Reset the Controller Are you using a USB extension cable? I have found that you can use a 50' USB extension
Question about Ap2622vf Autopilot Ap26 Rc36 Ac20 Rpu160
The control head seems to be working ok as it indicates the boat should be correcting course say to Starboard but the engines are not being turned to make that correction. There is no air in the line
Starboard needle keeps erratic behavior, engine does not lose rpm nothing seems abnormal, usual see this when gas has water but port engine runs fine from same tank and needle steady My thought is ...
I get an error StarBoard not connected. I have a T-17sxlg. My SB is connected to my computer. How is the T-17sxlg connected? you will need to connect both the video cable and the usb cable.
...connect the motor to the PC board. There are four power wires, two for each motor. The front motor which powers the lower rotor has two wires, black and white. The upper motor is powered by the rear ...
Question about STARBOARD T-17SXL
...mixed with 850°C exhaust gasses... But, you should also have a waterjet coming from the tube at the starboard back of the engine. No jet, first thing to do is remove the hose connected to it inside ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions