thread is caught on the spool holder, simple re-thread the machine.That generally works for me. Also you can try to push to spool holder in as close as possible to the spool pin to alleviate any gaps.
...spool of thread on spool pin. 3. Slide spool pin holder/cap (illustration 2) firmly over rim of spool to prevent thread from tangling. 1. Push in indent (illustration 1) on hand wheel disc. This will ...
Question about LS-1520 Mechanical Sewing Machine
...thread from the spool on a spool holder then the thread goes through a tension dial, on to another tension holder inside the case. Then make sure the thread is going through a lever that goes up and ...
...top. Let the thread feed off from the right-hand side i.e. "under" the thread spool, across to the tension disks etc. Also be sure that the thread is not jumping out of that first thread tension
...thread spool's thread keeper notch. Make sure you use the spool holder disk with the closest size to the spool of thread to help prevent that. This is pretty common with old fashioned spools like ...
Question about 1120 Mechanical Sewing Machine
...thread spool holder. Where can I get one and where do I put it on the machine? some thread spools are wound in a way that they need a vertical thread spool holder. I would like to find a vertical ...
Question about 1120 Mechanical Sewing Machine
spool, pull thread out through the small gap on the side of the spool holder, then holding the small arm on the holder outward insert the spool holder in to the socket and release after fully inserted
...thread spool on the spool pin and secure it with the spool holder. Use the end of the spool holder that is closest to the spool size. Bring the thread through first guide to the left of the spool ...
Question about 1120 Mechanical Sewing Machine
...spool of thread on it. Difficult to say. Some machines have a spool pin that can be pushed down for storage or transport. Your machine may have this ability. Or, perhaps someone has pushed the pin ...
Question about 1120 Mechanical Sewing Machine
thread spool and load thread on a bobbin and put both on the spool pin.
Be sure to thread each separately so the two threads do not become twisted. Your machine may also have dual tension disks
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions
