speaker wire or a short in the amp, itself. Try to disconnect the speaker wire from the amp. Did the clip light go out? No?? Ok take out the amp and send it to the service center as unless your a tech
...wire connectors here? If so, the springs go in first, then the clips sit on these to receive the wires. Hope This helps Try to see the 2 ends at the speaker you have open and arrange that 2 springs ...
...speaker wire connectors, but to connect them to the TV it has a different set up and I need an adapter of some sort. It says 8 and the greek letter Omega. The connector needs to be something that is ...
...speaker wire in place. All you need is regular copper braided speaker wire, nothing fancy. Then you strip about half an inch of insulation off the end of the wires, and pull back the spring loaded ...
speaker problem how do I remove the speaker wire from my surround speakers? is ther clips on the back of the speeker ?? if so push in on clip and remove wires.
Question about BRAVIA® DAV-HDX576WF Theater System with Wireless Speakers
...speaker connection? Sometimes spring clips are not spring loaded, so you have to lift some type of clip, push wire in than lock the wire down. Can't see from the picture-is it Sony DAV system? If ...
Question about BRAVIA® DAV-HDX576WF Theater System with Wireless Speakers
little sound coming out driver side speakers on my 04 dodge ram bought a 2004 dodge ram when radio is on passenger side speakers plays excelent although the driver side ones have only little clear ...
...outputs to the actual speakers,SOYOU RUN RUN THE FRONT SPEAKER WIRES FROM THE RECEIVER TO THE INPUT OR LOWER CLIPS ON SUB,THEN RUN WIRES FROM THE OUTPUT OR UPPER CLIPS FROM SUB TO THE FRONT
...repair shop where it has had a faulty standby PSU replaced. Now if I turn it on it says CHECKING SPEAKERS, then SPEAKER ON for a split second, then CLIPPING. It stays saying CLIPPING and does not ...
Question about VSX-305 Receiver
...speaker wires have not come out off the sockets at the stereo end .at the back of the unit you should have a place where you put the wires . Normally these have a couple of clips . Open the clips and ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions