...speaker / sub. Power up the amp and see if the light goes out. If it does you Sub is toast and needs to be replaced. If it stays on then the amp is done. Check the Ohm measurement of your speakers. ...
Question about A460 Car Audio Amplifier
...speaker and connect the other speaker. If it only shuts down with both speakers connected and the voltage is staying above 12v, the ohm load is probably too low and you'll need to rewire the
amp the green light come`s on for a sec then shuts off but the fan in side keeps runing..but i`m not geting any sound? thanks First disconnect the speakers and check if the amp. stays on.If don't your
...down with nothing connected, power it off, connect one speaker or component and power on again. Repeat the process until the amp shuts down and you may have found the bad speaker or other
...is to low or the voltage drops below 9 volts. First do you have at least 10 ga speaker wire and 2 ga power wire with an 120 amp fuse? You might need to upgrade your battery-alternator and add a ...
Question about PA1200.1 Car Audio Amplifier
...amp light staying the color that its was it was an old alpine amp with duo B circuitry but i hope you get your situation with this amp straited out check your contecions and if its bridege make sure ...
speaker wire connections to see if the amp will stay on. If the problem goes away when disconnecting the speaker wires try this: 1) Check volume level on zone one and zone 2 if connected. If it is too
...light and double checked every thing do i need to just get a different amp or wut? thanks Well as far as getting a different amp depends on what kind of subs or speakers you are trying to push. Also ...
amp. If your speaker wires are shorted it will make your amp shut down also, but since you were using it for a day or so my bet is that you burnt up one of your speaker voice coils and it's internally
Question about RSd1200.1 Car Amp
...shuts back down. With or with out amp, could also be blown speaker shorting out. Can unplug one speaker at a time till radio stays on or check each speaker with an ohm meter, should read 4ohm with no ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions