plug wire you will lose spark on both cylinders of the coil. So however you are checking for spark,(screwdrivers or spark testers) Check cylinders 1 and 4 at the same time. A good way to eliminate the
Question about 30 Cubic Centimeter Curved Shaft Gas Trimmer
...spark plug after getting a spark using a screwdriver, but no spark with the new plug ? Have also out in new fuel/oil mixture, clean air filter. Insure your sparkplug gap is correct to specifications. ...
...spark plug boot and hold it close to the engine block, pull the starter rope and look for a spark from the screwdriver to the block. Doesn't always work right and may not tell you for sure it isn't ...
...spark plug wire off the plug and put a screw driver in it have someone crank your engine and tap the metal part of screwdriver to metal if it sparks your good.the last is compression u need a ...
...spark plug and insert an old spark plug, a spark plug tester or a screwdriver into the end of the coil. Ground the spark plug or plug tester to the engine, then crank the engine and look for a spark. ...
Question about 1989 Ramcharger
spark plug wire, is going bad. Very hard to test a coil for weakness without test equipment that the average person doesn't have. Check the first 3 problems, first. If it still backfires, then replace
Question about 1989 Ramcharger
...spark plug wire, is going bad. Inside the Coil are two windings of wire and no moving parts. With shorted (melted together inside) windings you can still get a spark, but it will be weak. With open ...
Question about 1999 Sonoma
spark plug wire at spark plug end to ground. This isn't the right way. 2- Have you check fire with HEI spark tester. (The right way). To see a spark with the tester there will be 25k the spark to jump
Question about 1999 Sonoma
...in 12mm) to engine metal and have someone crank the engine. Observe spark or lack there of. Don't hold the screwdriver. Or get a spark tester <$10 at corner auto parts store.and plug into coil
Question about 1999 Sonoma
...spark tester With ignition module installed, measure secondary resistance with ohm meter from plug wire to cylinder head (not ignition module frame). Disconnect kill wire at the ignition module ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions