no power replaced the fuse still no power i have a durbrand ht-3916, surround sound system i have a sony subwoofer with no power. i found out that the voltage regulator (ic's)are bad. check that
Sony SA-wm40 is starting to buzz during the low pitch sounds. It probably buzzes all the time, you just notice it when it is outputting little volume. Check the cables for loose connections or replace
The speaker will cut-out after it has been playing a while. It will click-off, like it is going into a power-save mode, then back on for a few seconds or minutes...then back off again. Sounds like you
...Sony SA-WM40 subwoofer to hook up to my pioneer vsx-d912 k receiver. I'm also using 2 med/large speakers. The receiver has a sub pre out but i don't get anything from the sub when i connect the pre ...
Sony SW no sound No sound from SW. does this sub have an LFE output? if so, connect that to the LFE input on the reciever and make sure it is set up properly in the set up menu in speaker ...
my sa-ma40kicks off after it plays for a few minutes This sounds like a power supply problem. If it works after is sits or cools, check at the power supply for bad or disturbed solder connections, a ...
...Sony SA-WM40 subwoofer has power, but sound kicks out. I'll turn off power for about 5min and when turn power on, sound is back. Is something overheating? Probably, or the woofer coil itself is ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions