Questions & Answers for: socket light flickering Sewing Machines

light bulb and look at the base of the bulb socket.. you should see a tang there ( small tab) that makes contact with the bulb.. sometimes that gets compressed to a point that it won't make electrical

Sewing Machine light flickers/dims while sewing. Kenmore 385.18221 I just bought this machine and the light stays on when you turn the sewing machine off. Also, when you start to sew the light ...

...light went flickering and so the stitch goes on and off with the light. Tried to turn it on again there's no light and the machine wont start too. I think the light has something to do with the ...

light is flickering and the machine wont feed my cloth through and just sewing on the one spot at full speed even though i have only very lightly put my foot down. try adjusting foot pressure.not your

tried puting in a new bulb seen a flicker of light from the bulb and now the machine wont turn on Husqvarna rose. Sounds like it took out the local fuse in your plug. Happens sometimes.

...light socket down so you can access the bulb, bayonet 15W fitting. On the Stellas it is similar retracting light socket but there is a little lever on the back of the machine head that you need to ...

light bulb flickering in the machine. Can anyone suggest what went wrong and what things needs checking? It seems there is no power in the motor o Necchi sub 22 Stopped working after flickering in the

What's a fair price to repair a light bulb on 440QE? Dealer wants $600 to replace a circuit board in Bernina 440qe. Says that why the light isn't working. The light bulb flickered then stopped working

...light socket. Pull out light bulb. Push in light bulb with pins aligned to holes in light socket. Push in light socket. Replace face plate, screw and screw cap. NOTE: Only use same type light bulb ...

...light on Elna 6003. Can I use a LED bulb An LED bulb, https://www.sewingpartsonline.com/led-bulb-janome-mc9000-led.aspx , is available for the Elna 6003. To replace the bulb, you need to remove the ...