Questions & Answers for: slide projector schematic

...slide on the red projector. John You may still have a convergence problem, but what you need to do is to make sure that all of the bias resistors have been checked. That is why I am against the old ...

projector. settings to factory defaults. On the blue crt below the glass tube you will fine two metal tabs. By sliding the metal tabs (they move in a circular pattern) you can re-center the crt with a

control panel or a wire somewhere in the "cycle circuit" that is no longer connected. You should seek out a factory-trained repair dealer who has a schematic that can trace down your projector problem

bulb turned off, thought bulb went bad. replaced with new and wont come on. cat no # 63-25-79 was the only numbers found on the projector besides the name. Sounds like a thermal device that protects ...

...slide projector any help would so appreciated. yes same question as before with more info. thx bob Wow! An old Bausch & Lomb projector! While my expertise is with Kodak Slide Projectors, I can ...

...slide projector No schematics are available, so you will have to sleuth it. Look for hooks or holes where the springs go and possibly some wear. ...

...slide projector please? Projector has been in basement for years. Still runs and works but slow. Fan is noisy and gradually stops. How to get it working? Clean everything inside with a 1" paintbrush ...