Questions & Answers for: slave cylinder daewoo

...slave cylinder and the clutch will not hold pressure. The car will shift when off but will not go into gear when on so I am not sure why it will not hold pressure unless there is a hole in the hose ...

...your slave cylinder most likely. Assuming you don't have any leaks in the system. Your pedal is connected to a hydraulic cylinder. It should be up under the dash. Follow the pedal up until you see

I changed the master and slave cylinder on my 2000 daewoo lanos and u can feel it almost release than nothing. any suggestions You need to bleed the system.

...slave clutch cylinder, blead 3 months ago. Fluild levels fine, no leaks. Worked fine for a while, now depressed clutch sticks to floor. Please offer advice. Regards DARRYL Regards Darryl, you have a ...

clutch cylinder is the clutch cylinder,fixed to the engine block,the master or the slave no at the end of clutch pedal

...slave cylinder with anew one please provide the procedure and include the hydraulic bleeding procedure use a bar to hold slave cylinder arm in towards the slave ,then open bleed and assistant pushes ...

slave cutch cylinder be replaced as well, to fix the problem. Is this a good option or a waste of money? As long as the clutch is releasing and there are no leaks, replacing the slave will not help. A

cylinder, slave cylinder, the clutch plate thrust bearing and clutch, I have bleed it quite a few times and still nothing is there anything else I'm not thinking of any help would be fantastic

...slave cylinder and master cylinder need replacing. is it a autobox ? if so gear inhibitor switch might be the problem ,if a manual box does it make a grinding sound when trying to engage gear? if so ...

...on a 1999 daewoo nubira please help thank you Sounds like the clutch slave cylinder- if the rod is bent that's a huge issue and must be replaced, if this is so you'll need a new clutch slave