skilsaw model number 3400 15 amp Hello, This saw works great when it works.. it's only 3 yrs old and sometimes it starts and other times it won't or that it starts but stops..I had this checked out by
skilsaw. How do you get the wires from the old cord to release from the trigger switch? using a paper clip straighten one end and insert next to wire and push down and while doing so lift the wire out
...switch for 5250 skilsaw how to attach wires to new replacement switch Sometimes the wires are push fit and are held in with a sprung wire. If they are on this one try using a very fine ...
Question about - Skilsaw 77 Saw Hook - / Bosch Wdhk01 Rafter Hook Kit For Worm Drive
skilsaw wormdrive stops working but if I wiggle the cord at the handle it sometime starts and will run until I take my finger off the trigger. Now it won't start at all even after wiggling the co ...
cord on 5150 skilsaw I can't figure out how to get the switch to release the old cord. you have to take a pick or nail and put it in the hole next to where the wire is and it will release the wire
Question about 5400-01 7-1/4-in Skilsaw
where do you wire power cord on skil circular saw 5400 to switch switch has 4 terminals, does power cord wires go up and on left or right side or side to side Very easy to tell the short wires go to ...
Usually answered in minutes!
386 Questions
103 Questions
81 Questions
63 Questions