Questions & Answers for: single rear light stays

...located on top of the rear diff at the brake line clamp a single bolt with a wiring harness. replacement from NAPA comes with a new extension harness. use grease on the terminals before

...single filament' bulb installed in a 'dual filament' brake lamp socket ... OR .. you have a 'dual filament' bulb short circuited internally. Check your rear brake lamp bulbs (supposed to be 'dual ...

...single) and the power light just blinks. I hit the power button and the light stays on for a few seconds and than starts blinking again. This is a red light. Any ideas? I've been seeing alot of power ...

when my headlights are on my brake lights stay on One of your rear bulbs is a single filament bulb when it should be a double fillament stop/tail bulb.

...running filament and a brighter turn signal filament, and the back are just single filament turn signals. If you look in the parts list there is one part number for front bulbs, another for

...on with the headlight. The bulbs used in the rear signal lights would be a single filament 1156 bulb, whereas the bulbs in the front are dual filament, one for turn signal, one for running

...Its most likely your flasher unit take out the old one and get a new one auto parts store have them you front tirn signal are dual filament so they are on all the time the rear are single

...rear turn signals were single filament bulbs only, no running light. If all else fails get out your test light and start tracking the power wire from the harness connection. For a free wiring diagram ...

...rear turn signal lights are only single wire, is that correct? There is absolutely no flashing with the control button pushed, the light just stay lite. your flasher is bad & yes there is one one ...

rear stop lamps left, center and right. facts, Schematic on my screen all 3 lamps use the same single wire to glow. branks but not ground left uses GF04 ground wire to body. GF04 ground runs the other