...SIGNAL. However, the DVD player works fine. Can you please tell me what is the problem? Thanks Ken There should be a quick setup guide that came with this unit, to get the tuners going you need to ...
...signal starting at the jungle IC.Check B+ voltages as well.If good,check B+ voltages at vertical output IC. Missing? Troubleshoot power supply ... present = replace IC Use original NAP part # , no ...
...signal. Otherwise, its the mainboard. If u get all 3, then its your Y main board and probably a lower or upper buffer, depending on where burn is located on panel board. The problem is a $1.09 part. ...
signal from the remote commander when you want to watch tv. Therefore, it is always possible for some backward trending pulse to get into the set. For example, an electrical storm can destroy a tv set
Question about Grand WEGA KF50WE610 50" Rear Projection HDTV-Ready Television
...harm the tv if we leave it for the winter we live in alaska Your TV is not a rear projection it is a DLP if had been a rear projection the answer would have been YES! Cold would damage all 3 of Tubes ...
Question about Playstation 3 (PS3) Console
...signal to the tv from the console This is a common issue. All you need to do is hold the power button and wait for it to beep three times. Then repeat this three times and it will reset the setting. ...
Question about ViP722 DTV Receiver / 350-Hours Video Recorder
...harm splitter or trip surge protector, or trip electrical box, and no problem with Blu Ray or Harman/Kardon receiver. Licenced electrician says no problem with wiring. Installer blames electrical ...
signal, then that would rule out capacitors for the most part. If it turns on, and you have sound but no video, then this is either a blown projection tube, or a circuit has burnt out. If it turns on,
Question about TS-2000
...TV.If the signal is present with antenna removed / shorted, the signal may be coming in on the wiring in the home that brings the power to the TV. There may be little to ...
Question about TS-2000
...harm television or cord... Smart kid :) Agree with Steve about the power cord. The pixwllated picture breakup is due to a poor signal. This might be caused by - signal input cable not plugged in or ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions