...to just resolder it if you know the wire it should have a standard diaphragm with standard layout. should be asimple fix. thanks, Nate I need to take apart a shure pg58 wireless mic how do I do ...
...of a shure PG58 microphone so as to connect the wires from the three pin connector? popo the switch out a solder a pice of wire that bridges over the switch, that way the switch is always ...
Question about Porta-Com COM-60FC 6 Headset Wired Intercom System COM60FC Microphone
...shure microphone (which is crystallized), i don't use monitors. I am getting alot of feedback, what do you suggest to prevent this? Also which is the best microphone to buy that stops/minimizes ...
Question about PG58 Professional Microphone
I need to take the mic apart to solder a wire to the on off switch Pop off the switch. Peel off the oval label under the switch. Remove the two screws to get everything out.
Question about (LX287CC) Professional Microphone
shure pg58 that wont turn on. My Shure PG58 won't turn on. It seems like the wiring is good. Could it be that the switch is bad? It was used to be used at a rodeo so im sure it could plenty of dirt in
Question about T2 / PG58 Professional Microphone
older style 58 wirless - dead - was intermittant for a while - now nothing - had it apart and probably twisted the cartridge wires off - how do I get the cartridge out of the upper body of the mic The
...touching wire to contacts 90 degrees from green wires. Contact the following for repair: ...
shure pg58 wire diagram Contact Shure for a service manual
shure pg58 with on off switch wire diagram Here's the schematic...good luck!
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions