...wheel bearings 3/ susppension arms 4/ ball joints 5/ track rod ends worn 6/ steering shims loose 7/ damaged cv joints or drive shafts (transverse engines ) 8/ Prop shaft missalignment (rear wheel ...
...wheel vibrating from side to side! Also need to check all steering ball joints and adjust steering box backlash/play in the straight ahead position. HEY I HAVE A QUESTION YOU DONT FEEL THE PROBLEM ...
...pain and you do have to take the whole front end apart to SHIM the steering bracket so they will mesh /make contact . After this is done the plastic piece that holds the parking brake might not ...
...wheel and tire assemblies from vehicle.Remove the two caliper guide pin bolts. NOTE: Note the positioning of the two rail shims between the knuckle's machined abutments and the brake shoes.Remove ...
...steering system. if its the airbag assembly be careful with that. undo the battery and let it sit for a half hour then study that box and come up with some sort of shim(styrofoam?) to keep it from ...
Question about 1992 Explorer
...steering wheel pulsate and shudders when braking lightly When braking lightly the brake pedal pulsate and the steering wheel shudders. We have replaced the disc, brake pads, steering ends, upper and ...
shimming why my rav4 j shimming at 80MPH have a wheel alignment done as it is most likely a castor wobble. Check all steering ball joints and connections. Check balance of tyres both dynamic and ...
Question about 20 Hp 42" Deck Lawn Tractor
...steering wheel, it could need some shims under the shaft due to wear. Also check and make sure the bolt on the cross member is tight as well as the steering gear half moon. Another good resource for ...
...steering boxes without the adjusting screw it will be necessary to remove the cover and to select a shim to remove in order to adjust the lash. As a matter of interest, excess lash is often caused or ...
Question about 20 Hp 42" Deck Lawn Tractor
...steering wheel only clicks when steering back to the right,the wheels turn together when doing it manually Likely the steering gear and pinion and/or bushings have worn down so far at a point that ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions