Questions & Answers for: setting poulan 2375 carb

2375 ''wild thing'' poulan saw hard starting after carb rebuild what are the initial settings for high ,low carb screws .mine are now adjustable after overhaul Through trial and error on fairly new ...

...sounds to me that the needle in the carburator is bad.you need to rebuild the carb. and check the settings when your ...

...the Poulan chain saws. Once you adjust the low idle from factory setting it will work Also, increase the amout of oil you're putting in your gasm sometimes if it's too little it will cause ...

WHAT ARE SETTING ON POULAN 2375 CARB. start at 1 turn out on both

...poulan chainsaw. Have plenty of spark but engine doesn't fire. Using a fuel mix of 50:1. I Have the engine in the run position. Have removed plug and dried it several times. Am using a cj7 plug Does ...

Screw mixture settings I have a chainsaw which went for service, came back wouldn't run. the guy fiddled with the two mixture screws to no avail. what is the correct base settings for a walbro carb ...

Poulan Wild Thing 2375? hello,the starting point for adjustment screws is 2 turns out.turn in til lightly seated so as not to damage them. there are 2 or more style carbs used on saw,some have plastic

...Poulan Wild thing 2375 Start at 1.5 CCW from lightly seated then tune for performance like this: Carburetor Adjustment by Madsens.com http://www.madsens1.com/saw%20carb%20tune.htm CW is leaner; to ...

...poulan wild thing 2375 bogs out when throttle My poulan wild thing 2375 bogs out when i try to throttle it. What are the carb settings (the high and low jets) ( idle screw) so when i throttle it it ...

chainsaw won't idle- runs fast only Gently Tighten the carb adjustment screw fully tight then adjust it out 360 (full turn) then again a further 180 ( half a turn) and your idle speed should be set ...