Questions & Answers for: setback building code

HI I got a 1993 mainbuilt eagle boat. with a 130 hp honda .also have a 24 inch setback plate. Ihave got the top plate above the prop 2 inches above thebottom and I'm haveing a hard time to get out of ...

...occupied setpoints of 70degF Heat and 78degF Cool. During unoccupied times, it is recommended to setback Heat to 62degF and setback Cool to 85degF. If your system is experiencing problems

...then the problem reappeared. The reason I asked was to see if it is a power supply problem. If the setback had been set on 86 I would suspect you were having power fluctuations causing the heater to ...

...that is not what my door is set at. Most kwikset locksets will work on either 2 3/8 or 2 3/4 inch setback. There should be two holes on the latch where door knobs fit thru the door. If yours does ...

building official and apply for an "after the fact" permit. This will likely entail your having to expose wiring and foundation components etc., but at least you can get it insured once you have the C

Please tell me the setback requirements for Michiana, Indiana http://www.stjosephcountyindiana.com/DocumentCenter/Index/289 Below is a 2005 Planning and Zoning Regulation paper. If you load it in your

Hi, what do the terms comfort, setback and standby temperature setpoints mean please. Just moved into new house, we have instruction leaflet but dont know what these terms mean. Thanks for any advice.

I'm building a home there are 10foot setbacks if I were to go15 foot setbacks am I able to drive on that setback You should ask your building inspector/code enforcement.

...Building and Safety - Los Angeles County Public Works https://dpw.lacounty.gov > bsd > content > faq Does a 96 square foot playhouse with a projected square foot area of 120 square ... What are the ...

How do I reset a PECO TA-170-001 Thermostat Hello, a PECO TA-170-001 Thermostat that is SETBACK mode and my question is, how do I re-set it back to FACTOR set mode? Again, this is a TA-170 0thermostat