'cannot setup' message. can you help? Check if Zone 2 is 'On' if it is set it to 'Off' using the front panel button. Hitting the 'Recieiver' and 'Setup' buttons is the correct way to set the system up
set to ZONE 2. See page 41 of the manual. The volume level going to the sub will probably need some tweaking. Check out page 7 to see how to manually adjust volume levels, or get it close by adjusting
...set up okay. Zone 2 has been turned off. I would say check the cable version not everyone knows this but there are different version HDMI cables such as 1.0,1.1,1.2 and the newest 1.3 cable these are ...
set of speakers. This amplifier has a second zone output option. What you need to do is connect your outdoor speakers to the second zone on the reciever, than you can turn it on and select the desired
set ZONE 2 to ON (page 61), you can't use the System Setup menu. â?¢ If you cancel the Auto MCACC Setup, or leave an error message etc. It's all in the manual. Some background on the process
...Set MULTI-ZONE to OFF. â?¢ Disconnect the iPod and USB memory device from the receiver beforehand. 1 Switch the receiver into standby. 2 While holding down ENTER on the front panel, press ...
...Set MULTI-ZONE to OFF. 1 Switch the receiver into standby. 2 While holding down HOME MENU on the front panel, press  STANDBY/ON. The display shows RESET  NO . 3 ...
...2 While holding down the TONE button, press and hold the STANDBY/ON button for about three seconds. 3 When you see RESET? appear in the display, press ENTER . OK? shows in the display. 4 Press SYSTEM ...
...Zone 1/Room 1 with the audio. Also, when the audio issue occurs, I have to power off all devices to get the cable TV to work again. Any ideas? I would check your input settings. If everything is ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions