...washer set up so that bar is suppose to move up & down, or is it set up so both right & left sides are suppose to be firm and not move? Anything else I need to know in order to fix that back left ...
washer that leaks only during the spin cycle often has a leak in the main drain hose. Inspect the entire hose and correct any problem you find. Alternatively, the steel or plastic outer tubs can rust,
Question about Energy Star WCVH6260F Front Load Washer
...washer resetting to its correct 28 minute cycle. Instead it just eats the coins and robs you of washing your clothes. Any suggestions? remove slide cover .. move the slide lever back untill it is on ...
...set. Place pump over motor looking to (make sure) the top three prongs go inside three holes left in the black rubber piece. Once you line and they go inside line the motor to where the for rubber ...
...set compared to the original wear marks on the pulleys and gears, centered). I also manually turned the engine and the belt started "walking" off the gears and pulleys but never got worse than about ...
washer, take the dryer off and set it aside. Unplug the power cord. When you remove the top, that should expose the upper side of the solenoid valves. Sand has probably been embedded in the valve seat
...washer combination and can be removed from the long bolt/stud that is attached to the seat track rails. Jack the car up high and set on jack stands to get enough room to lie underneath the car. Be ...
Question about 24032\24036 Top Load Washer
...set the washer back down (do not slam it) and the rear of the washer should now be level. Using a level, check the washer front to back and side to side to make sure it is level in all directions. If ...
...washer does this, I have to remove the timer, remove the side plate (it is necessary to straighten a couple of bent retaining tabs, then straighten the retaining tabs on the black connector on the ...
...the red "lock" light began to flash. I then unplugged the washing machine and reinstalled the solenoid unit into the housing. I then plugged the washer back in and it s now working. Hope this
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions
