Questions & Answers for: set power boost valve

...boost kicks in it loses power and coughs and splutters would this have any thing to do with the big hole in the centre muffler? cheers the hole in the muffler cant hep. how does it run without the ...

...power production. The lobes of a diesel cam are optimized for low-end operation and won't run well at higher revs (since they were designed for an engine that will never see those higher revs - the ...

...power. (Both of these sensors are new!) All vacuum pipes are connected to correct places and not blocked - turbo works well. Hall sender at camshaft is secure and in correct position. EGR valve has ...

...line is set up on my subaru, need 2 know what pipe goes where from the power boost valve and also to the engine plz, thanx check if this helps: ...

...power or engine "ping" due to overboost by the turbocharger Common Problems The wastegate solenoid would be the most common cause for code 31 to set Code 31 does not indicate a problem with the ...

power to engage the silinoid (sp?). sometimes it starts right up and other times it only makes a clicking sound. it is easier to start when warm. also after starting it gets a rough low idle and feels

...power doors were working fine. Mechanic replaced starter motor. Boost was needed to start vehicle after installation of starter motor. Now it is taking longer and longer after ignition switch ...

...power at all??? any ideas?? If the truck is a diesel, I would look at the EGR valve and the throttle position sensor.  The TPS and even the EGR should turn the check engine light on and set a ...

...boost sensor, check valve and air filter. There is probably a pressure regulator in your system. Of course it could be a MAP sensor engine load , have you had the computer codes read? There are ...

...set, you will likely notice reduced power output. In the case of Ford vehicles, this may apply: "The PCM checks for a minimum throttle intake pressure (TIP) PID reading during engine operation, which ...