Questions & Answers for: set fusing unit correctly

Ad

Question about Office Equipment & Supplies

1 Answer

...Set the fusing unit correctly. We have replaced this before so we are familiar with replacing the fusing unit. Any suggestions? Thank you. Look in your owners manual for the set of reset keys you ...

Ad

Question about Aficio SP C410DN Laser Printer

2 Answers

...set fusing unit correctly on Ricoh Aficio SP C410DN. Have just changed thermister in fusing unit. Take the unit out and install it again, making sure it is in all the way and sitting correctly. Then ...

Ad

...set the fusing unit correctly? How to fix the Error: "Set the Fusing Unit correctly" Ricoh Aficio SP C411DN & C410DN Color Laser Printers Instructions: 1. There is a short Wire Jumper (color: ...

Question about Aficio 450 Copier

1 Answer

fusing unit is not set properly This is a common problem on older ricoh with  high counts the unit has a connector at the back to receive the fusing unit the connector on the fuser may have bee ...

Question about 20070206 Smoker

1 Answer

...SET TIME/ /CHECK ON UNIT; LIGHTS ARE SLOWLY BLINKING TEMPERATURE 77 DEGREES;;;HEAT IS NOT WORKING/ INSIDE OF UNIT IS NOT EVEN WARM//RESET PROCEDURE/STILL NOT SOLVED//UNIT HEATER IS NOT WORKING//I ...

Question about Aficio SP C232DN Laser Printer

1 Answer

...set time after the fusing lamp has turned on. ?? Defective thermistor ?? Incorrect power supply input at the main power socket ?? Defective fusing lamp 1. Check the voltage of the wall outlet. 2. ...

Question about DSm645 Digital Imaging System

1 Answer

...set fusing unit 1. Check if the fusing unit is correctly set. 2. Check or replace the actuator for fusing belt sensor. 3. Replace the fusing belt sensor. 4. Replace the IH inverter. 5. Check the ...

...in ricoh af 1022 i get paper jamming in fuse unit haf paper in fuse unit and haf in side in machine . Check paper in tray and make sure it was set for correct direction (8.5x11 landscape or

Question about Aficio 1022 All-In-One Laser Printer

1 Answer

...Fusing warm-up trouble • Detected temperature of the heating roller temperature sensor (TEMS) does not go up a given range of temperature even after a lapse of given period of time at warm up. • The ...

Question about Aficio 1022 All-In-One Laser Printer

1 Answer

set period of time has elapsed after the warm-up is started. Remedy: 1 Check the fusing unit for correct installation (whether it is secured in position). 2 Check the open/close operation of the right

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

k24674

Level 3 Expert

8081 Answers

Cindy Wells

Level 3 Expert

5940 Answers

Marvin
Marvin

Level 3 Expert

85108 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...