Questions & Answers for: service electric tv remote work

...the TV itself do? Do they work properly? If not, the problem is going hand-in-hand with the remote and again, the problem is internal and service or a firmware update, if available, may resolve

...customer service was no help. Any suggestions? i have a toshiba tv how do i reprogram it ,evry time the electric goes out the tv goes out to be reprogram and i for got how and do not have i

...remote. I have plugged TV directly into Electrical outlet, to no effect. Is there a servicable fuse or circuit breaker that would have cut off power, in case an electrical spike during the rain ...

...electric, propane or kerosene heaters, flames from fireplaces or candles, stoves, etc.). If there are bright lights shinning directly behind the TV or on the screen, turn the lights off. If problem ...

...t have a code. i have service electric cable will you give the remote codes. tv vizio (32'') remote control did not work on CH button.is anyone have a same problem?.How do I reset remote ...

...TV or on the remote. It sounds that the main board has the fault. Checking and locating the faulty component to this board, is a very skilled work. Products powered by electricity should be serviced ...

Electric source is good but no lights on at tv. Would there be a fuse?? Might be. But, to go forward, you must have thorough knowledge in electronics and previous work experience to repair a plasma TV

...with patience. Pull up older posts. http://electronicshelponline.blogspot.com/ If the remote control is found OK; check and replace the infra-red sensor inside the TV. Contact any service

...tv and contains easily damaged CMOS circuitry. A power outage would not affect a battery operated remote control. Change the batteries in the remote for a brand new set of Duracell batteries. If that ...

...tv button Not sure if service remote as described in service manual will respond if ch up/ ch down unplug tv the repower doesn't work and per manual ch up/ ch down and power via service remote should ...