Questions & Answers for: sensor pin

...sensor. Pin 11 is the midpoint of the resistor network and voltage at Pin 11 will change with vehicle charging system voltage. The expected voltage at Pin 11 is shown in the table below. The ...

...sensor. Pin #1 gray wire is air temp signal. Pin#2 gray/red is signal return. Pin #3 LB/Red is MAF signal. Pin#4 TN/LB is MAF signal return. Pin #5 BL/WH is ground Pin#6 RED/YLW pcm power relay ...

...pin in ckp sensor, replaced sensor clean pin con out with elect.cleaning solvent,check pin key on. three wire, yellow has batt voltage,brown wire has grn. blue 6.2 volt ref. installed new ckp code ...

...ZX2 used a push in sensor with a retaining pin. You remove that pin and pull the sensor out. So far I haven't found a part store that carries that type and have had to get the sensor from the

...sensor connector, Pin #4, GREEN/BLACK is the "sensor ground"  and Pin #5, RED/YELLOW is the "sensor input" for the IAT. For the 3.5L engine: At the MAF/IAT sensor connector, Pin #1 ...

pin crank sensor read the two reluctor rings, and can a four pin sensor be substituted, what is the layout of the pins? I believe the dual ring setup is like a cam sensor and crank sensor in one unit

...pin PCM harness connector and mainshaft speed sensor harness connector. 6. Check White wire for continuity between 25-pin PCM harness connector "B", terminal No. 14 and mainshaft speed sensor harness ...

...pin PCM harness connector and mainshaft speed sensor harness connector. 6. Check White wire for continuity between 25-pin PCM harness connector "B", terminal No. 14 and mainshaft speed sensor harness ...

...the sensor should make it vary from zero to five volts across two pins and five to zero volts across two other pins. This is a three wire sensor. One pin is a "common" pin. the other two are

sensor connector pin 1, harness side and ground; and between TSS sensor connector pin 2, harness side and ground. For OSS, measure the voltage between OSS connector pin 1, harness side and ground; and