Questions & Answers for: seat washer

Ad

Question about T&S Brass B-0228 Deck Mixing Faucet - Less Nozzle

1 Answer

...washer. The valve seat looks ok but....? I dont have a model # but it is in a commercial kitchen, Swivel type, two levers ( hot, cold) 8 " center to center. T & S Brass is all I can read on faucet. ...

Ad

Question about T&S Brass B-0228 Deck Mixing Faucet - Less Nozzle

1 Answer

washer. The seat is what the washer seals to inside the actual faucet. This seat is removed by a seat removing tool, also purchased at a home improvement store. Once you remove the seat take it to the

Ad

Question about T&S Brass B-0228 Deck Mixing Faucet - Less Nozzle

2 Answers

...washer on top has not got trapped under the metal fixing. If all is ok line up the seat and tighten. Had exactly the same problem, unreadable instructions and a spare allen key. searched on the ...

Question about T&S Brass B-0228 Deck Mixing Faucet - Less Nozzle

1 Answer

...seat that the rubber/plastic washer seals on... Check the seat condition for wear, especially a "line cut" in the brass seat from where the water has eroaded the seat, this could cause your leak. If ...

Question about T&S Brass B-0228 Deck Mixing Faucet - Less Nozzle

1 Answer

...seat dont use a flat washer, use a bleved washer. When you look at the washer it should have like a little rise in it to the center this will let the washe sit deeper in to the seat. Best of luck ...

Question about T&S Brass B-0228 Deck Mixing Faucet - Less Nozzle

1 Answer

...washer. after filling gas tank, gas drips from the carburetor. Needle and seat problem probably with the needle worn or seat worn or both OR needle sticking OR float and/or float level adjustment ...

Question about T&S Brass B-0228 Deck Mixing Faucet - Less Nozzle

2 Answers

how to change a front seat belt anchor You give no make or model of car. Usuallly you have to remove the seat. You will need a trox rachet to loosen the anchor from the vehicles side. You must torque ...

Question about T&S Brass B-0228 Deck Mixing Faucet - Less Nozzle

1 Answer

How to keep an elongated toilet seat in place If you mean that it moves about a bit ..... if you go on ebay you can obtain toilet seat retaining plastic nuts , they are quite wide and do offer a bit ...

Question about T&S Brass B-0228 Deck Mixing Faucet - Less Nozzle

2 Answers

Washer Hose Replacement - Pump to Endgate Removal Procedure Remove the left front seat. Refer to Bucket Seat Replacement in Seats. Remove the rear seat. Refer to Rear Seat Replacement in Seats. Remove

Question about T&S Brass B-0228 Deck Mixing Faucet - Less Nozzle

1 Answer

...good practice to use a tap seat cutter tool to clean up the face that the new washer sits on If you haven't done that operation , chances are that the seat is bad and the new washer will not seal ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Plumbing Experts

Donni Steen

Level 3 Expert

687 Answers

Brad Brown

Level 3 Expert

18060 Answers

Tom Chichester

Level 3 Expert

51937 Answers

Are you a Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...