...slot damage can only be repaired by having the entire handheld serviced. * Some expansion cards labeled as SD or MMC do not actually conform to the SD or MMC specification. If the expansion card will ...
SD card won't lock into the expansion slot. It keeps popping out. Is there a fix? Try flipping it vertically or horizontally, and see if it will fit in better If the lock mechanism is physically ...
...work like that or not? If so, it could be something like that in your memory slot. =-] it can depend on the type of sd you're using. just the suggested sd on the manual. the palm sd cards will do ...
...slot and is not recognized by the camera. I can hold it in place to allow the Nikon to read it, but when I release it, the card pops up and contact with the camera is lost. The card is a ScanDisk 2GB ...
Question about Trail Scout 11-9500c Digital Camera
...SD SLOT Most likely the SD card is not being pushed in far enough to lock into place. You really need to use your fingernail to push it in past flush until you hear a clicking sound, at which point ...
...SD slot. It uncovered what looks like a small 3 pin connector and now the camera will not turn on. Any suggestions? It might be a ribbon cable connector you "unhooked". Try to replace it back to ...
SD/MMC expansion slot lets you keep shooting longer". The "SD/MMC" specification is a good indication that the camera can only use the "SD and MMC" standard. There may be a firmware upgrade that would
...It can lock sometimes if it is loose,as you put it into the slot. If necessary tape it in unlocked mode. It (the switch) will appear on the upper left hand corner of the SD card or micro SD
Question about 2GB microSD Memory Card
...SD card with a push to release system. looking at the back of the camera the card slot is on the bttom to the left. if the card were to be out the top right hand corner would have a notch removed. to ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions