...screw it went through but had no effect (the outside was far enough away from the inner important area)). So, here is the deal. If your Ryobi BC30 only runs when you have it set on half choke or less ...
screw holes as well. Be sure to put these two screws back in the same hole they came out of. IMPORTANT > > > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn
...hole they came out of. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns outward. Put the rest of the carb back ...
...hole they came out of. IMPORTANT > do not tighten these two screws down. Only screw these in until they LIGHTLY seat. Now turn each screw one and one half turns outward. Put the rest of the carb back ...
Question about 30 Cubic Centimeter Curved Shaft Gas Trimmer
...carb cleaner and spray into each hole along with the inlet of the carb (this is where the air comes into the carb). Also while you are there you may as well clean the filter with soap and water. Good ...
Question about 30 Cubic Centimeter Curved Shaft Gas Trimmer
...screw hole. Put both screws back where they came from and turn each until it LIGHTLY seats. Now back each screw one and one half turns. This is the factory setting. If the bike still does not want to ...
screw hole and make sure it come out the pilot hole and in the carb mouth. i have lint from a rag block a pilot jet before to. and yes sycnhonieing the carb will help after you get all 4 holes banging
...carb. Remove the vacuum valve and keep it away from any spray. Remove the choke, air and throttle screws then spray into every hole you can find. The spray should go in one hole and come out another ...
...hole in the carb. Remove the choke and the throttle and air screws and spray into those holes as well. What goes into one hole should come out of another. Wear goggles to avoid getting any spray in ...
...the float in the carb is getting stuck the way to tell is loosen the screw at the very bottom or carb and see how much gas comes out it should run forever if only runs for a few secs the clean out ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions