Question about KSM90 Ultra Power Series Stand Mixer
...to do something but found "nada". what am i missing The solution for both of these is a large screw that sits at the base of the head where the head and the base meet - you'll see it when you ...
...this moring!! Solution: 1- Lift head. In the lifted position you will see the head of an adjusting screw. Turn it to the left say a half turn. 2- Lower head and see if it is still too low. If so, do ...
...the mixer head wobbles. They said kitchenaid said it was an adjustment problem. I know there is a screw underneath that holds the hinge pin and it should try to be tightened first. She said she ...
...living in Suriname, so there isn't any waranty. Any ideas? Remove the back housing by removing one screw and liftingand pulling rearward. Remove two screws holding the metalic edge trim. This ...
...the mixer head loose. Is there a way to tighten it up -- would like to know how to get to the screws holding the head to the base. Thanks! Turn the mixer upside down and you'll see the screws
...this problem, here's what I did a few minutes ago that fixed it. Lift the head, then turn the screw that connects the head to the base to the left. You're basically unscrewing it. That screw ...
Question about KSM90 Ultra Power Series Stand Mixer
...have a Tilt-head style mixer, you can adjust the beater/bowl clearance by turning out the adjusting screw. Place your bowl on the bowl screw cap, Place the flat beater on the agitator shaft and lower ...
droopy head on Kitchaid Stand mixer Raise the head and adjust the screw that is now exposed from the front over the top of the bowl where the head hinges on the pedestal. Screw out to raise the head ...
Question about Kitchen Aid KSM150 Artisan 5 Quart Stand Mixer
...motor housing. Now the motor head "wobbles" when the mixer is operating. I've tried adjusting the screw located under the head but it continues to wobble. Could I have bent or broken something? The ...
Question about Kitchen Aid KSM150 Artisan 5 Quart Stand Mixer
I have a KitchenAid Professional 600 6 Qt, 575 W mixer, not a tilt head model that has a bad head wobble and looking how to fix it. I was able to fix it myself, there are 3 screws holding the head to ...
Usually answered in minutes!
1,098 Questions
332 Questions
312 Questions
169 Questions
102 Questions