Questions & Answers for: Poulan screw heads Photography

Ad

...air/fuel mixture on my weedeater. Gary JP4... remember that short piece of hose you used to get the screws out? Why not just use it to make the adjustments to begin with. I found a piece of refer ...

Ad

Question about Poulan Garden

1 Answer

Poulan TE475Y motor upside down Poulan TE475Y 17" gas trimmer has been built with motor upside down. When trimmer is in correct position, the gastank cap is pointing towards the ground also. Andbody ...

Ad

...that would allow me access to the service manual? Thanks for any help you can give me. Are the jet screws fitted with slot heads or 'D' heads? 'D' heads require a special tool to adjust and are not ...

Question about P3416 16Inch 34cc 2Cycle Gas Powered Chain Saw

1 Answer

The screws do not have a flat head? How do I adjust the carb? The carburetor high end and low end adjustment screws do not have a flat head? How do I adjust the carburetor? Its a poulan p3416 16" ...

Question about P3416 16Inch 34cc 2Cycle Gas Powered Chain Saw

2 Answers

need tool to adjust small splined carb adj. screws . will not rev up and stay revved up , on polan leaf blower. Sellers on Ebay have the tool. Of course you have to register as a member to buy. The ...

Question about 25cc 2-Cycle Gas Powered String Trimmer with Curved Shaft #P1500

1 Answer

...high speed but will idle Remove the air filter and look at the carburetor. There are 3 adjustment screws. The Philips-head screw adjusts the angle of the throttle lever and thus, the throttle speed ...

Question about FL1500LE 25cc 150 MPH Blower

1 Answer

heads on them, but they can be turned. You can buy a tool for the type of head they have on Ebay. I use a plastic automotive type wire terminal connector and tap it over the head of the mixture screw.

Question about 25cc 2-Cycle Gas Powered String Trimmer with Curved Shaft #P1500

1 Answer

...screw next. The carb may also be due for a gasket and diaphragm kit to be installed (they ALL do at some point) as the ethanol-laced fuel hastens the demise of sensitive internal carb parts. You will ...

Question about Poulan/Weed Eater No. Te475 952711797 17" Le Gas Trimmer/Edger

1 Answer

my trimmer if it idles good but wants to die when i try to accelerate It either needs the L mixture screw adjusted (counterclockwise 1/8 to 1/4 of a turn) or the metering diaphragm inside the carb has

Question about Poulan/Weed Eater No. Te475 952711797 17" Le Gas Trimmer/Edger

1 Answer

...tool was indeed required to adjust the carb. Poulans typically have the "splined-head" mixture screws. I grab their heads with an automotive type 22 gauge wire connector (tapped onto the head to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...