Questions & Answers for: KitchenAid screw heads Photography

Ad

Question about KSM90 Ultra Power Series Stand Mixer

1 Answer

...to do something but found "nada". what am i missing The solution for both of these is a large screw that sits at the base of the head where the head and the base meet - you'll see it when you ...

Ad

Question about KSM150PS Artisan Series Stand Mixer

1 Answer

...this moring!! Solution: 1- Lift head. In the lifted position you will see the head of an adjusting screw. Turn it to the left say a half turn. 2- Lower head and see if it is still too low. If so, do ...

Ad

Question about Artisan Series Tilt-Head Stand Mixer

2 Answers

...the mixer head wobbles. They said kitchenaid said it was an adjustment problem. I know there is a screw underneath that holds the hinge pin and it should try to be tightened first. She said she ...

Question about KSM150PS Artisan Series Stand Mixer

3 Answers

...living in Suriname, so there isn't any waranty. Any ideas? Remove the back housing by removing one screw and liftingand pulling rearward. Remove two screws holding the metalic edge trim. This ...

Question about KL26M8XOB Stand Mixer

1 Answer

...the mixer head loose. Is there a way to tighten it up -- would like to know how to get to the screws holding the head to the base. Thanks! Referring to the diagram on: ...

Question about Artisan Series Tilt-Head Stand Mixer

2 Answers

...mixers pivot on a pin which goes thru the head and the base. This pin is held in in place with a screw which you can access from underneath the base. Try tightening the screw and see if that ...

Question about KL26M8XOB Stand Mixer

2 Answers

...the mixer head loose. Is there a way to tighten it up -- would like to know how to get to the screws holding the head to the base. Thanks! Turn the mixer upside down and you'll see the screws

Question about KSM90 Ultra Power Series Stand Mixer

1 Answer

...this problem, here's what I did a few minutes ago that fixed it. Lift the head, then turn the screw that connects the head to the base to the left. You're basically unscrewing it. That screw ...

Question about KSM90 Ultra Power Series Stand Mixer

1 Answer

...have a Tilt-head style mixer, you can adjust the beater/bowl clearance by turning out the adjusting screw. Place your bowl on the bowl screw cap, Place the flat beater on the agitator shaft and lower ...

...although is still locked down. Make sure that the hinge pin is locked up firmly with the grub screw that is accessed with machine upside down on a towel. It is right up the middle of the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...