Questions & Answers for: Husqvarna screw heads Photography

Ad

...How can I get under the bobbin holder? I was able to gain entrance into the area by taking out 1 screw (star head), slightly pulling on the plastic compartment to cause a small opening. I then ...

Ad

Question about "Chain Saw - 16" Bar, 3 Hp

1 Answer

...heads, then turn both screws CW to stops (lightly), then back each 1-1/2 turns CCW. This is a basic setting, so the engine should start and run. Start the engine and allow to warm up, then pull the ...

Ad

Question about Forest & Garden 125l 18" Gas Trimmer

1 Answer

...from the bumping and I can not pull the old head off to replace it Hi winipig1 the heads dont pull off they screw off. Spray some lube oil behind the head and it should free it. It will undo ...

Question about "Chain Saw - 16" Bar, 3 Hp

2 Answers

...keeping my saw to idol, other than that it runs fine. what are my options? Adjust the Low idle screw so that it doesn't die out. On most saws, to adjust the idle, look for an opening that

Question about Forest & Garden 125l 18" Gas Trimmer

1 Answer

My weedeater head won't spin. If you take the head off and fire it up the bolt that the head screws onto will spin fine but when u screw the head on it does not spin. Have you put the head on properly

Question about 28cc Gas Line Trimmer

1 Answer

...screw heads. On the non-conventional ones, you can use automotive type wire terminal spade connectors. Before you put them on though, you need to note the exact position of the mixture screw you are ...

...plug and new fuel and it fires ok. Wouldn't stop so I added a washer under the 'earth' screw and it now stops. Problem is poor acceleration Hi. I inherited a 1998 Husqvarna 265 rx. Got ...

...the fuel tank from the saw, to do this start by removing the guide bar and chain, remove the three screws securing the top cover and remove, remove the two screws holding the air filer and remove, ...

Question about 531004054 Throttle Wire

1 Answer

...of husqvarna 128c Hi,here is the illustrated diagram of the 128C trimmer head. Most strimmer heads screw on anticlockwise and require the inner head to be held or locked in order for it to screw

...screw heads, do not remove any of the plastic housing screws, now carefully draw the tube out through the plastic handle/trigger assembly, once out pull out the old drive shaft, grease the new drive ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...