Questions & Answers for: Dodge screw heads Photography

Ad

Question about 2002 Caravan

1 Answer

Dodge Caravan Hello, I changed my head gasket, and now my car won't quit excelerating it is really loud aslo. I also stripped out two screws on my exhaust manifold. I tried to tighten them down. Do I ...

Ad

Question about 2002 Durango

3 Answers

...How do you get the interior door panels off to get to the speakers? there will be a torx head screw somewhere around not the door handle but the handle on the door, and then a phillips head ...

Ad

Question about 2004 Sprinter

3 Answers

...are heated, so there are wires that remain attached when you slide it off. This reveals three screws that you can get at with a torex screw driver without needing any flexible shafts etc. It ...

...electrical connectors from the camshaft position sensor. Remove camshaft position sensor mounting screws. Remove sensor. Loosen screw attaching target magnet to rear of camshaft and remove magnet. ...

how do i change my front lights on my durango. The screws on front are stripped and my allen wrenches wont work.can i go from inside? if your trying to change the bulbs you have to do it from inside ...

Question about 2001 Durango

1 Answer

...run hot - engine head or head gasket could be problem also there could be an air pocket - bleed screw -if your car has one is located close to thermostat housing - small brass ...

1989 dodge van 318 after replacing blown headgasket now have water coming from hole in middle of head just above intake manifold.what could it be? hole is kinda like half hole. if you've got no spare ...

can not find headlight adjustment screws YOU NEED A HAYNES REPAIR MANUAL.IT HAS 3 HEAD LIGHT ADJUSTMENT SCREWS WITH PHOTOS.IT WOULD BETTER TO TAKE TO A GARAGE.SHOULDNT COST MUCH BUT GET A PRICE ...

...remove passenger side inner door panel Almost all door panels are attached by: SMALL PHILLIPS HEAD SCREWS-  these are found all around the door panel.  They are normally hidden by; small ...

Question about 1994 Caravan

1 Answer

how can i remove a rusty screw in the head lights depending how bad the head is on it if it is a star head get a Philips screw driver tap it down on screw with hammer just to shock it spray some WD40 ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...