Questions & Answers for: Maytag screw heads Furniture

...hinge part for lid How do I get the top of the PAV2300AWW Matag washer off so I can get to the screw that holds the part #1477, female hinge part for lid off? My old matag had 2 screws in the ...

...off of my Maytag front load gas dryer to reach the baffles when you open the door, there are two screws they are phillips head screws that hold the hinges to the dryer take them off the door is on ...

...in wash If your agitator is blue, and rather short........There should be a small hex head screw about 1/2 way down that holds the agitator on the transmission shaft. Check in your wash ...

...fingers in the back holes and pull forward. Make sure the ref is unplugged. Remove two 1/4" head screws in the front and two phillip head screws by the lights. One 1/4" head screw straight in the ...

How do I change the tumbler belt on a MayTag DE410 Electric Dryer? simple remove the two phillips head screws at the bottom of the front panel lift up from the bottom and remove the front panel don't ...

handle on bottom freezer door is loose. Screw on bottom of handle appears to be neither a philips or flathead screw. just seems like a teeny tiny rivet.. Inside the handle is a floating ...

paddle came off inside dryer drum I need to open the top so I can put more screws in remove 4 screws around the door perimeter,remove door,then the front panel will pull off towards you then remove 2 ...

...the hole on the inside of the handle on the end that has come off.  There will be a loose screw head sitting in there.  You need to get that out and screw it back into the hole in the ...

...top or control panel so ill tell ya how to do both CONTROL PANEL; remove the inner phillips headed screw on side and tilt downward MAIN TOP; remove phillips headed screws from bottom of front ...

...screw heads have broken and we cannot get it out. How can we get the screw out? Without seeing how or where the screw is located the Idea below may work. I assume, what is left of the screw head is ...