Questions & Answers for: screw heads ATVs

Ad

Question about Quads 125cc Full Size Adult 4 Wheelers ATV

2 Answers

...closed). On the lifter there is a small lock nut. loosen the nut so you can turn the adjustment screw. Turn the screw in till it touches the spring cap. You should be able to slightly move the ...

Ad

Question about 125cc Full Size Adult Quad ATV

1 Answer

...the engine and plugs smell of petrol? You need to adjust the carburettor. Mark where the throttle screw is to start with and then slowly screw it (in - I think) to reduce the petrol flow. The other ...

Ad

Question about 2005 Big Bear 400 4x4

1 Answer

...head and put the notch to the top of the head and there should be a big flathead bolt thing to unscrew on the bottom end of your motor and un screw that and look for something that is carved in ...

Question about 2012 Gator XUV 4x4 550

1 Answer

...made that too easy.... If there is not one on the oil fill plug, there should be a (hex headed?) screw below the fill hole somewhere... remove it and oil should flow/trickle out. To be sure, once ...

...and cut my necht 150cc auto 4 stroke quad out why is this If you can reach both positions, use a screw clamp to tightne the areas Thanks ...

Question about Yamaha Big Bear Yfm350fw Air Filter

1 Answer

clean out a yamaha big bear carburetor ethanol in carburetor remove screw or large hex head plug in bottom of carb..drain and replace screw or plug.. . A K&N must be clean, lightly "oiled",, and ...

Question about Yamaha Big Bear Yfm350fw Air Filter

1 Answer

screw in it and it's not a gasket problem. It's a hole in the head. Oil is spitting out when running no snowing at all that is the oil pressure line for the heads oil delivery. It should have a copper

Question about Yamaha Big Bear Yfm350fw Air Filter

1 Answer

is the 2008 ATV 125 4 wheeler a 2 stroke Tommy, that question is a bit hard not knowing the make. However, ALL 2-strokes MUST either get their lubrication from pre-mix or an oil injection tank. Also 2

Question about Yamaha Big Bear Yfm350fw Air Filter

1 Answer

Carburetor screws won't come out. How do I get the out. If you are talking about the float bowl screws. Use a fine hacksaw and cut straight across the screw head, then you can use a flat blade ...

(1994 yamaha 250 4x4 timberwolf CARB.) There is a philips head screw on the same side as the idle screw with spring. what is the adjustment on that philips head screw if close to head, gas adj, if on ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...