...scope movement.ie.if you hit your target two inches low and you move the adjustment the appropriate number of clicks towards "up", will you hit higher or lower turn adjustment counterclockwise to ...
scope out of elevation adjustment Have tried several different rails and rings If you are sure that the scope was mounted correctly to begin with, ie plenty of elevation left THEN you can install a ...
...scope issues with elevation adjustments I have an older Tasco scope. It is a variable power with target turrets. The elevation turret does not raise or lower the elevation. How do you fix this? Take ...
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
...adjustment is maxed out Bushnell banner scope, Remington model 700. Shoots 6 inches high at 25 yards and elevation screw is maxed out. Try reversing the rings. Move the back one to the front, and the ...
Question about Zeiss 3.5-10x50 Mc Rifle Scope : 5214899972
...elevation adjustment refuses to work in either direction. The dial simply will not move to make the correct adjustment. Can anyone suggest a resolution. Cheers Firefly Tried google for zeiss rifle ...
Question about CenterPoint Adventure Class 3-9x40mm Riflescope with Adjustable Objective a
...such as one piece of black vinyl tape under the scope in the front mount this will cause your point of impact to go down and give you more adjustment for the up direction. worked fine for me on a ...
Question about BANNER RIFLE SCOPEPower: 3-9X40 / Reticle: Green/Red Illuminated
...scope's adjustment is elevated as high as it will go, it is still hitting low because it is actually pointing down because apparently the rear ring is higher off the barrel than the front ring. The ...
...is the one you will use for elevation. If you have 3 knobs, the left one is for parallax adjustment, focuses the scope for specific ranges. the top knob is the elevation adjustment in this case
Question about 3-9x50 Prostaff Riflescope In Matte 6313
...adjustment on windage and elevation screws to set the scope correctly Check you mounts. If mounted properly you should have enough. if they are not moving at all you have prob broken the fine wires ...
Question about 3-9x50 Prostaff Riflescope In Matte 6313
adjustment to zero to start over. If you want to center the cross hair in the scope Rotate elevation down to it stops then count up clicks to it stops then half number and rotate down that number then
Usually answered in minutes!
284 Questions
229 Questions
170 Questions
130 Questions
106 Questions