Questions & Answers for: sawzall blade loose

...Sawzall #6527 Clutch Adjustment I've had this tool for several years and like it very well. When it was nearly new, the blade shaft quit moving and I took it in for repair under warranty. The repair ...

Sawzall goes dead when horizontal top right Works fine with blade verical or top left but when held with blade horizontal top right goes dead. could be a break in the cord or a loose terminal at the ...

...sawzall 6527-27..it runs ok til i try to saw then the blade stops is there a safty clutch or a overload or .... there is a gear protection type of system in this tool, to check I would first remove ...

blade moves normal until you try to cut something then it just stops but motor still runs. Your drive has become detached or loose, you need to disassemble and find out whats broken and replace. Or ...

...sawzall blade Blade is stuck so I cannot change it; blade is loose when the blade clamp is turned but something (feels like the pin) is not moving out of the way to release it. All efforts (including ...

...blade release lever). Provide photos (if possible). I'm going to assume you are talking about a sawzall here. If it is an older model with a set screw, then there will be a hole, or slot on the side ...

...breaker bars to get the nut and bolt loose. More times than not, the bolts are locked into the bushing(rust). They usually have to cut out from between the frame. Sawzall. Have plenty of blades

...blade Terri, this is grease leaking from seal on col-let shaft, or loose bolts/cracked casing. Take apart and repack gears and housing with lithium grease ( do not over pack) and change seal if ...