...max idle rpms. Turn screw back in a quarter to half turn and it should be idling smoothly. Be careful here and get someone to hold saw if necessary but hold in throttle to full speed and do the same ...
...max gas it cuts off. When I try to saw it wants to cut off also. I changed the gas and tried that but still it is stalling. You need to set the mixtures for the carburetor. You will find a Low and ...
...saw is in low at speed or when is not in use for cut.When you pull the handle to start cut then the adjust the high one at max speed. If you need more help come back.Post / thumbs / testimonial are ...
Question about "Chain Saw - 16" Bar, 3 Hp
...saw. As soon as I either operate it to max feewheel speed or require full power when sawing the engine stops. This first occurred when cutting a large oak beam recently. I have changed fuel, removed ...
Question about 16 Inch Gas Chain Saw MCC1635AK
...shut then open 1 1/2 turns. On idle adjust to where it will idle good and chain is not moving. At run speed adjust slowly to where it runs the smoothest at max R.P.M.s. Hope this helps.Thank
...saw dust has been removed from the jet passages and the passages are clean like new. reinstall the o rings,if used ,the flatwasher ,the spring and the needle jet and screw in the needle jet all the ...
...saw runs a max speed(go by ear) and idling speed(idle down enough so chain does not spin while finger off triger). For the spark plug gap, go about 20 thousands of an inch. I hope this helps you
saw course using one, and know that I can at least handle that weight and power, and would be useful to be able to compare the specs with the ones I am looking at to buy) Cheers Not too sure what spec
Question about Forest & Garden No.967012396 345 16" Gas Chain Saw
...saw dust has been removed from the jet passages and the passages are clean like new. reinstall the o rings,if used ,the flatwasher ,the spring and the needle jet and screw in the needle jet all the ...
...saw up max revs,adjust high speed jet, in or out till you get max revs,then screw out one quater of a turn.That lets enough fuel thru to cool the sparkplug tip..If thats no good,redo the carbi.Check ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions