Questions & Answers for: saturn door hinge removal

door (7 screws inside the glove box) you can see where the striker needs to be positioned to engage the latch. Probably only a small adjustment is needed. See the link below for parts break down. http

...saturn 3 door. Driver door hinge part # 21170657 removed old piece one nut on door two on frame. removed plastic whell well cover to get to back to install new part but can't find access. I just ...

...saturn it is in hte bottum of the center console. you need to remove the side panels to the center dash console. they are just hanging there by a hinge. I would recamend buying a chilton or haines ...

...door of my 2004 Saturn Vue. I'm having a hard time adjusting the door to reclose properly after replacement. No matter how I adjust the door, it seems to drop about 1/2 an inch when you open it. Any ...

door window down on my 2001 Saturn SL1. It will not operate. the rest of the window work fine. What could my problem be? Check the Switch it self, it may be bad or dirty. You can try the button on the

...saturn ion driver power windows switch will not work. Fuse good and passenger window switch works. The switch unit is good had a new on put on still did now work. Problems seems to be in wiring after ...

...door the hinge pops oil hinges.check that door & front fender aren't rubbing. looks like the problem is the door is weaker than the door latch.the door bends before the lock on the latch lets ...

Saturn sc driver door clicks loudly when opening and closing Center hinge clicking how do you change center hinge On a Saturn SC2 1998 I have this on my car right now it maybe the door frame where the

...Saturn ion Good question hard problem . The cable is likely not broken just streched so now the level inside the vehicle can't travel enough to pull the cable far enough to pop the latch. You need to ...

...door hinge in my saturn l300 is bent. Now the foor will not open. Should I replace the whole Door? how do I get the hinge off to replace it if it's actually welded on? it would be unlikely that the ...