...it closed if sand is in it will do further damage. Can you gently extend the lens and jiggle it to see if any sand comes out. Most likely this fault needs repairing to open it up and remove the
...sand will jam any digital camera lens. You should be extremely careful to never allow sand to get anywhere near any digital camera. The gears are very small, thus the smallest piece of debris will do ...
...sand can stop a lens gear from working and possibly cause a broken gear. The parts are so small that in order to see the grains of sand which cause the problem, it may be necessary to use a magnifier ...
Question about Coolpix S550 10 Megapixel Digital Camera (Graphite Black) with 5x Optical Zoom + 4GB Memory Ca
...sand becomes lodged in the lens bellows it will jam. I have never after thousands of repairs had any lasting success in trying to repair. When taking a camera around water and sand buy some sandwich ...
...sand when the lens was open, I immediately got a lens error and could see the sand stuck in it. after removing visible pieces of sand it worked completely fine. now after a couple of weeks I got the ...
LENS HAS SAND I GUESS AND WHEN I TURN IT ON IT JUST TURNS OFF AND I BOUGHT IT THE INTERNET AND I DONT HAVE INSURANCE FOR IT OR NOTHING IF ANYBODY KNOWS WHERE TO FIX IT PLEASE HELP..AND WAT SUX I BERLY
Question about PowerShot SD870 IS Digital Camera
...sand in your lens and it is jamming upthe gears. One grain of sand will cause the lens to fail! You can try to take the lens apart and clean out the sand but it's not easy and an opened lens usually ...
sand in lens. The is I think some sand in the lens. When it's turned on the camera opens and shuts its (telescopic) lens, and then asks me to turn it off and on again. If I turn it on it just asks me ...
...sand particles around the lens barrel of your camera. A single grain of sand can jam in the gaps around the barrel, preventing the barrel from closing. Use air or a thin sheet of paper to dislodge ...
Question about COOLPIX L810
...sand all over the lens mechanism. First, I cleaned the area by blowing air to remove all sand particles (this took me almost a day). In my case, I did not have to remove the lens from the body of the ...
Usually answered in minutes!
1,383 Questions
1,133 Questions
959 Questions
944 Questions
808 Questions