Question about Krystal Clear Model 635 Pool Filter Pump 1500 Gph
...do in the house!! The 635 pump is not strong enough for the 18x52 pool nor does it filter out fine silt and sand...it sucks it up and spits it right back into the pool thru the return. Good luck to ...
filter it has what they call a sock on the fuel pump we cleaned it and it was full of sand and dirt and it still cuts out.when you start it up and push the gas all at once it starts cutting out but if
...sand, or rust in the tank that is choking the fuel filter.Then clean the throttlebody if problem persist.In the most extreme cases the air intake and or filter maybe blocked but this is rare. If you ...
...sand filter has great flow for awhile, and then it stops, If I backwash and rinse the flow returns for a few hours. I vacuumed the pool yesterday and backwashed and then rinsed, A bunch of sand came ...
Question about Pro Series Sand Filter -36" Tank
...bad pressure gauge. Also you said the pressure is the same but you did not mention if it is still spitting out sand. If it is and the laterals are all ok I would recommend replacing the spider
sand filter keeps spitting out into my pool broken laterals replace or new filter
...filter that is spitting dirt back into the pool. I do not see and obvious problem when I dissassemble the filter. Check the standpipe gasket. Its a small part, but could be the problem. Also, look ...
Question about SAND FILTER, PRO SERIES
...sand filter ? if it is spitting sand take top off shop vac sand out pull vertical pipe up put your hand in and either unscrew or they unclip dont break check to see if broken if broken then replace ...
Question about SAND FILTER, PRO SERIES
...sand filter.... frustrating!! Had problems with these types before also. As the filter ages it warps and thats a problem lol. You said you cleaned the recesses Im hoping top and bottom and lubricated ...
Question about SAND FILTER, PRO SERIES
...out when i turn pump on sand filter either sand too old and small pieces getting through or crack in laterals or pipe remove sand by shop vac then check amount of sand is on label if not 3/4 ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions