...TV (HDMI) and connected it to my Samsung 40 inch HDTV and I can only receive the HD channels, all others give me "not supported mode" message. change the source of the input using the remote's source ...
Question about Televison & Video
TV (Samsung LN46A750) by doing the following: * Press the "Menu" button on your remote control * Press the "Up" or "Down" arrow button to select "Input," then press "Enter" * Press "Enter" to edit the
Question about LE40B650T2 40 in. Full HD Crystal LCD TV
Samsung LCD running for couple years with no problem - cable,DVD,PS3. Turned it on today and cannot get a signal from any input. I can see all of the TV menus so the panel is fine and was able to do a
...TV Hi, To change the input source for your TV, you can use your remote to change the video source by following these steps: Turn on your TV. Press the TV/Video or Source button. The current source ...
samsung tv sound but no picture i have a Samsung HLP 5674wx/xaa and i have NO PICTURE and just sound , in the back of my tv there is a slight picture on the wall in the back of the tv ? Solution #2 ...
...samsung lcd tv there is some problem i cannot connect my acer laptop with samsung lcd tv i try to press fn+F5 button my laptop screen goes blank but the there is nothin at all on the tv screen.but ...
Samsung Tv Faults permanent black horizontal lines on samsung le26b450 lcd tv after plugging laptop into it. It worked fine for a couple of hours but when I tried to change the source input using the ...
...Samsung TVs, you will only see the inputs that are connected. Confirm all of your sources are properly connected (and powered on) to the TV. If you still cannot see your inputs, you may have a ...
Question about Samsung UN40HU6950 40 Inch Ultra Smart
...Samsung TV work. The TWC tech says it is a problem with the TV and insisted on connecting using the component inputs. I told him that wasn't acceptable since the component inputs are analog, not ...
Question about Samsung UN40HU6950 40 Inch Ultra Smart
...Samsung smart TV and I have blue screen with red power indicator. Could you please advice the problem and how to fix it? Sounds like u have an input selection problem. Find the source or input button ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions