Questions & Answers for: saab 9 engine removal

...Saab 9-3 ARC? Filter is under the plastic cover correct? Yes, filter is under plastic cover, and be sure to use SYNTHETIC OIL ONLY! Good luck! Whatever you do, don't use a multi-splined Socket. Use a ...

engine removal what are the steps for engine removal disconnect engine to the trans mission , remove bolts and nuts.disconnect engine to the chassis , remove bolts and nuts, then remove the engine to ...

...Saab 9-5 Turbo Any one have picture or diagrams describing how to put back the vacuum hoses? Thanks. The turbo is located on the front cylinder bank, under the engine cover and heat shield. The ...

...saab 2.2d engine error code p1222 I have a saab 2002 2.2d - cant define the error code p1222, car knocking / missing - cant id the problem . All help welcome. Thanks these do suffer from blocked EGR ...

...saab 95 Easy to do. It is in the front of the engine. Remove the Exhaust guard (engine cold). It is right and below. Need to take out two screws, remove the sensor, replace with new one. See ...

...Saab 9-5, 2.3t smokes when leaving the accelerator after letting go of the accelerator, while driving, the car smokes. Not noticing smoke at any other times. Looked for oil leaks on the head, but ...

...sensor location on 2000 saab 3.4 engine The crankshaft position sensor is located on the front of the engine above and behind the starter. The starter will need to be removed to get to the

...saab 9-3 se turbo asap please #1 Heat up engine to make oil flow better #2 Put car up on jack stand or ramps #3 Place pan under engine and remove filter being careful not to burn yourself #4 Remove ...

...saab 9-3 and is it hard to get to Follow the top radiator hose back to the engine. At the end of the hose should be the T-Stat housing. I believe you'll need a 12mm socket to remove the housing for ...

...Saab 9-3 Convertible... cant remove ignition key, ... yes car is in reverse Just had engine swap done... now this If the key has not been coded with the new ECU the electronics will not release the ...