Questions & Answers for: Chevrolet Venture rtv

...Procedure 1.Install the thermostat. 2.Install the thermostat housing and gasket. 3.Install RTV sealer, GM P/N 1052366 or the equivalent, to the thermostat housing bolt threads. . 4.Install

...} side. You must have the thermostat & new gasket ready with you. I also, suggest you bring Red RTV sealant which has " Hi - Temp." written on it . From Permatex company. You put very little on ...

...housing and thermostat. Clean matting surface.Installation Install thermostat and housing Add RTV sealer to bolt threads Tighten bolts to 18 lb ft. and install everything else in revers Re fill ...

...fall down preventing the sliding door to close properly. If it is the weather strip, place some RTV silicon to keep it in place when you re-install the weather strip back in place. Thank you for ...

...Install or connect the following: The thermostat The thermostat housing The gasket NOTE: Apply RTV sealer, GM P/N 1052366 or the equivalent, to the thermostat housing bolt threads. The

...Install or connect the following: The thermostat The thermostat housing The gasket NOTE: Apply RTV sealer, GM P/N 1052366 or the equivalent, to the thermostat housing bolt threads. The

...and gasket. Install the New Thermostat1Apply a light coat of room temperature vulcanizing (RTV) sealer to the threads of the thermostat housing bolts. 2Set the new thermostat and new gasket ...

...new thermostat with the pellet towards the engine. Install the outlet to the intake manifold. Apply RTV sealant to the housing bolts and tighten to 18 ft. lbs. (25 Nm) Reconnect the radiator hose to ...

...bolts in on each side. Make sure the gasket stays aligned with all the bolt holes. You may use some RTV on the gasket but if the surfaces are good and clean you shouldnt have to Step 6: tighten all ...

...the throttle body. Does it fit tight in the hole? You can seal loose fittings with a high-temp RTV (Red) silicone sealant/adhesive. Several small leaks add up and your engine, heat/AC, will be ...