Questions & Answers for: rpm needle...

...rpm needle hits 35000 - 20000 rpm. then after a minute or two it drops to 15000 rpm. that is the lowest it goes. also at sertain times the rpm needle swings between 10000 - 25000 rpm at start-up for ...

where is the rpm needle suppose to be, for good idling? 700 to 900 rpms after warm up I have a have a Honda civic and the rpm needle does not move it stay on 1 rpm. what wrong with it please help!!!!

...RPM needle does not move. What could be The RPM needle does not move. What could be wrong? Also, no washer fluid gets to the rear window when I push the rear window wiper button. What could be wrong ...

...it has a dynajet stage one kit in it K&N air filter pipes are not stock it runs good at high RPM when at low RPM it runs like its getting to much fuel it has ajustable main needles would it ...

...rpm needle to play? For Rpm needle play problem,click the link below to troubleshoot the ...

...rpm needle go crazy on my lesabre 1997 3.8l but no check engine ligth and the engine is running fine its really just the needle so iam thinking it migth be the rpm sensor but where is it????? dont ...

rpm needle does not work how can i fix? on my 2004 buick lesabre my rpm gage and my gas gage stop working when i turn the car off the gas needle stays way down below the F and when i start the car the

rpm needle? The car shakes and the rpm needle jumps up and down it(the rpm needle.) doesn't stay at one which is normal. the rpm gauge works off impulses from the coils /ignition module. Fix the cause

...RPM needle is stuck below the little pin RPM needle is stuck below the little pin. how do I get the needle to go back the other way or can I not you can replace the entire gauge cluster with one from ...

needle for maximum RPM using the same technique as the high speed needle. 7. Move the throttle to maximum and wait for the engine to clear out. Adjust the high speed needle valve for maximum RPM. This