Questions & Answers for: rotor distributor

...distributor rotor and shaft for installation-1987-90 2.5L engine Fig. 4: Rotor position with the distributor properly installed-1987-90 2.5L engine Disconnect the negative battery cable. Remove the ...

Ad

Question about 1996 Suburban

1 Answer

Distributor AND ROTOR REPLACED ON MY 1996 GMC, 4.3 V-6 ENGINE, TRUCK 3 MONTHS LATER TRUCK STARTED MISSING AGAIN, PULLED THE DISTRIBUTOR CAP AND FOUND THE ROTOR MELTED ON THE TOP, REPLACED THE ROTOR IT

Ad

...rotor and distributor cap and connect all wiring. Tighten distributor cap to 18-23 inch lbs. (2.0-2.6 Nm). Reconnect battery cable. Start vehicle, and check timing. If timing needs adjustment, refer ...

Question about 1993 Mercedes Benz 400 Class

2 Answers

...rotor cap is bad Your distributor bushing is bad, causing the distributor to wobble when running. Get it checked out for repair and/or replace the distributor. Take off the cap and check the play in ...

...rotor or distributor rotor? The brake rotor usually gets rusted on....putting a hammer on one portion of the rotor face and striking the rotor face 180 degrees from the first hammer should do it. ...

rotor button on the distributor housing first. Then you need to make a mark on the distributor housing that will line up with a mark on the engine itself. When you put the distributor back in back the

Question about 1998 Sierra

1 Answer

...rotor terminal. Lower distributor into opening, engaging distributor drive with drive on camshaft. With distributor fully seated on engine, rotor should be under No. 1 terminal.Install distributor ...

...distributor. If the rotor does not point in the right direction yet, lift the distributor and turn the rotor a little farther and insert it again until it points to the No. 1. If the rotor keeps ...

...rotor off the distributor shaft. NOTEInspect the distributor cap to housing seal for damage and/or cracks. Replace if cracks are detected.To install:Install the rotor onto the distributor shaft ...

Distributor rotor keep burning up in my chevrolet s10 why? I have a 1991 Chevrolet s10 v4 that keeps burning up distributor Rotors. Changed spark plugs and wires. Changes distributor cap and rotor and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...