...roomba 4210 discovery. Both brushes stopped working. Everything works fine except for the brushes. I called roomba technical support and they said i need a new one, because i damaged something that ...
roomba discovery stops, beeps twice with status light on. battery is new 1 month old Cleaned the shaft that the spinning brushes are connected to. Used an eyeglass screwdriver to remove the brush.
...Roomba Discovery My Rooma Discovery 4210 has one slow-moving wheel--one of the two spins just find, the other slowly. I can't find an obstruction, but I can't see what might be lurking between the ...
goes in circles goes in circle Discovery 4210 http://www.fixya.com/support/t766773-repairing_stuck_wheel_roomba_discovery
...Discovery 4210 goes in cirles Do you have it set on "spot"? This causes Roomba to start out in circles, expanding and expanding until a certain time and then returns by going in circles, making ...
Question about Roomba 4210 Bagless Robotic Vacuum
roomba 4210 replaced aps battery still does not work discovery 4210 battery was not holding charge. I reset the charging system and charged for 72 hrs. It worked for 1 cycle and then it quit. I ...
Question about Roomba 4210 Bagless Robotic Vacuum
Roomba Discovery 4210 was "played with" by 3 year old It will not clean and track across the room. I just spins around in circles. The clean button does not seem to respond well. You must hold it down
Question about Roomba 4210 Bagless Robotic Vacuum
...roomba discovery) it just makes a 'quack' sound and doesn't move. the battery on your roomba is dead, try charging it for 16 hours, after that if it still does not work. you need to replace the ...
Question about Roomba 4210 Bagless Robotic Vacuum
...roomba the light goes out and nothing happens. Can anyone help. It is a Discovery Model 4210 Are you using the home base or are you plugging the charger directly into the Roomba? If you are using the ...
Question about Robotic Floor Bagless Vacuum
...Roomba Discovery 4210 (2007) is approaching the recharging dock at a fast speed, which prevents it from lining up properly to dock. It hits the front of the base and tries over and over to dock. My ...
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions