...not at idle usually around 2000+ had valve cover off, loose push rod is it my lifter? maybe not turn engine over until the rod is loose now twist the push rod with your fingers does it look
...no load Generator does not go down to idle when no load applied. Auto idle switch ok and idle control module replaced with no change. Check the idle control rod Is it bent or hanging up on
Question about 2001 F250 Super Duty Super Cab
...Idle when warm generally you can see the rod for the valve through the holes on the valve when warm watch the valve raise rpm approx. to 2000rpm you should see that rod move up let off it should rest ...
...idle will cause bearings to go out and throw a rod. Lookj at the valve cover if it is a jdm you will know if it is a SIR or a SIR2, SIR has larger font for the DOHC and smaller font for the VTech The ...
Question about Outboard Motor Bass Fishing Boat Rod Reel Oil & Grease
93" 115 H V4 Johnson outboard motor will start and idle fine Starts and idles fine but when on plane boggs down and dies. Replaced the prime bulb, checked the gas lines for leaks but problem still ...
"2002 dodge grand caravan broke a connecting rod "2002 dodge grand caravan broke a connecting rod and overheated, i replaced the piston and rod along with all gaskets, it starts but idles rough ...
...rod(no movement when lowering throttle back down..).. Runs a bit too high(rpm) at idle and on low near off ,it goes right to cut off.-is a bit too sensitive.loud rpm on high..New governor spring may ...
2005 harley v rod cuts off at idle starts off great but dies out when i idle Check your fuel pressure. If it's low, then check fuel strainer on pump for restriction.
idle but when you give it gas the noise gets quieter and faster You need a trained technician to listen to this, but it sounds like a connecting rod and or a crankshaft main bearing noise. I lean more
Question about 20 hp 42 in. Deck Lawn Tractor - CA Model
...rod) at idle position. I can get it to set just a little off of full throttle, but no better. The governor rod will turn less than a 1/4 turn back and forth but doesn't make any unusual noises. These ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions