Questions & Answers for: rinnai heater wont light

...rinnai rhfe 1001fa heater and when its real cold sometimes it will shut down all the lights go out and i have to shut it off then turn it back on and sometimes it still wont start and i will leave it ...

wont run pilot light stays lit on pilot only, when you turn the heater up to run, it turns on, then clicks, then shuts off completely. I have 2 heaters doing the same thing. check the flame detector ...

...wont stay on rinnai energysaver 1000ft I havent used it before - we just bought this house with it instaled. when I turn it on the fan goes for a minute or so, the ignition fires and the red light ...

rinnai avenger 25 wont switch on and has a key symbol displayed There is definatly power however, there is no green or red light.. I think one of my children has put the childlock on and I have no ...

WONT START AND LIGHTS FLASH OUR RINNAI RCE 318 WON'T START AND THE LIGHTS FLASH try interrupting power to reset.if it still doesnt work consult manual for code to flashing light sequence.also make gas

rinnai rhfe-263fa changed board ran good for 10 minutes. now wont light again. gas press. good. if i chock off exhaust-half way- it will light. What are you getting for error codes? Press the economy ...

heater just started shutting off on its own. I cleaned everything i could without dismantling. put it back together and samething light the stove stays on maybe a few minutes then shuts completly off.

...rinnai 556f wont run. I turn it on and the on light quickly turns red. Also the filter light comes on even after I clean the filter. Press the up arrow, down arrow and economy button all at the same ...

...see an arcing, this is the igniter. With a power outage there is no telling what may have happened. With only limited knowledge of a gas heater you should call a Rinnai service guy. Good luck, ...

...rinnai floor heater mod 630530. The pilot wont stay lit . I have installed a new thermo couple . please help be sure the thermocouple is in the pilot's flame and hold down the pilot lighting button ...