Questions & Answers for: ribbon set direct thermal

set for thermal transfer printing. Check to see if there is any dirt on the ribbon spindle gears or on the ribbon motors. For the latter you will need to remove the electronics cover. If there is dirt

...ribbon occures when you are set for thermal direct printing in the driver or printer and you should be set for thermal transfer in the driver in printing defaults off of the advanced tab and the ...

it had a ribbon? If you don't use a ribbon, you are using it in Direct Thermal mode. You need to set your driver to use Direct Thermal rather than Thermal Transfer, this is in the settings under Media

...ribbon and being set to "direct thermal" where it should be set to "Thermal transfer". Thermal transfer printing uses a heated ribbon. See here ...

ribbon installed, the sensor will set off that alarm. If you WANT to print using direct thermal, remove the ribbon. If you want to print using ribbons change the Print Method in your front panel setup

...ribbon and set the menu to Thermal direct. labels print OK but the error light flashes and the ''Ribbon In'' error keeps displaying. The transition to ribbon-less printing went fine on a Zebra ...

...the ribbon take-up does not turn. If the printer is set to Thermal Transfer then I would suspect a bad Power Supply since the ribbon take-up is driven by the power supply and not off the main

...set up for either(with the thermal trasnfer option- ribbon unwind and rewind assembly) you can use either ribbon- with thermal transfer stock, or direct thermal- with direct stock. You can tell the ...

...Transfere if using ribbon, Direct thermal if doesn't use ribbon, ru calibration if needed, or if doesnt work, you can do the manual calibration and/or reser to factory default. Hope it helps.

...Direct Thermal" (no ribbon) or "Thermal Transfer" (with ribbon). If you want to print using Direct Thermal labels you need to select Direct Thermal from Media Settings in the Menu accessed from the ...